Workshop, Security & Care for FXR

Description Used with 3.4375" to 4" bore with OEM base pattern. Plates simulate stress conditions when boring and honing; which prevents distortion...

Description Used to install (round wire type) piston wristpin retaining rings MCS 508585 (OEM 22589-83A). Fitment 84-99 Big Twin (Excl. Twin Cam) 8...

Description Used to positively align wheel with swingarm; swingarm spacers and caliper brackets. Prevents getting your blood pressure way up there ...

Description Black with bright red knurled grip. Used to hold the two halves of the M8 spring loaded scissor balancer gear in alignment; before remo...

Description Pulls and installs alternator rotor as used on M8 motors. Overcomes the strong pull of the high performance rare earth magnets that are...

Description To be used with JIMS 978226 valve spring compressor tool for 8-valve M8 engines. Will allow working with the M8 18100043 and the upgrad...

Description Used to lock flywheel; of assembled engine. Installs through crank position sensor. Great for use with compression leakdown testing and...

Description Used to remove & install the inner cam bearing 9215 (non-full needle); 9298A (full needle) and 9298B (full needle) on M8 models. Th...

Description To be used with 978211 wristpin remover tool; for use on M8 models. Fitment 18-26 Softail 17-26 Touring 17-26 Trikes Product Details B...

Description Used to install OEM 11000134 / 568378 sprocket shaft seal in left side case; straight and without distortion. Alternator stator can sta...

Description Crankcase bearing tool. Removes and installs both left (sprocket) and right (pinion) MCS 921180 / OEM 24605-07 crankshaft main bearings...

Description Ensures correct alignment; seal protection; and depth when installing the seal Fitment85-06 5-speed Big Twin (Excl. 2006 Dyna) (NU)Prod...

Description Installs & removes inner primary support bearing & seal (MCS 530510 / OEM 9135 bearing and 520091 / OEM 9231 outer bearing only...

Description Consists of 5 transparent master cylinder covers which have a bleeder cap on top. With a; not included; vacuum pump the fluid is pulled...

Description - Transmission holder is securely to be clamped in a vice - Used to hold the transmission shafts in perfect alignment for a quick and e...

Description Blue anodized aluminum. With laser etched tappet locations. Used to store the tappets and anti-rotation pins when removed from the engi...

Description Incl. top end; cam chest; primary and transmission organizer stands. When a bike is taken apart there are a lot of screws; nuts and bol...

Description For transmission inner and outer side cover; top cover and trap door. When a bike is taken apart there are a lot of screws; nuts and bo...

Description For inner and outer primary components and covers. When a bike is taken apart there are a lot of screws; nuts and bolts that need to be...