Workshop, Security & Care for Dyna

Description Used between primary chain and front motor sprocket to prevent primary movement when loosening & re-torquing sprocket & clutch ...

Description Used to remove 509395 / OEM 9063 bearing in outer primary cover Fitment 65-88 Big Twin 67-80 XL Sportster (NU) Product Details Brand:...

Description Prevents clutch hub from rotating when installing/removing clutch hub nut. Fitment41-84 Big Twin (NU)Product Details Brand: Jims Cat...

Description Used to repair the (often damaged by OEM plastic breather valves) breather hole. No need to disassemble the cases. This tool will ream ...

Description Used to install and remove the retaining ring (snap ring) of the Timken bearing outer race in the right side crankcase Fitment69-02 Big...

Description Installer only for race of 9028 sprocket shaft bearing; Also used when upgrade converting 03-17 Twin Cam with roller bearing to the ear...

Description Used to install and remove sprocket shaft bearing race from left side crankcase; Note: Used with 920542 JIMS driver handle Fitment69-02...

Description Removes and installs the 1-7/8" hex nut (35211-36 and 35211-91B); the thin but large (left hand threaded) nut that holds the rear trans...

Description Used to install the crankshaft assembly into the left crankcase Timken bearing Note: 978332 socket is required for this tool and must b...

Description Used to easily remove the inner Timken bearing from the sprocket shaft without removing shafts from the flywheels Fitment55-85 Big Twin...

Description Incl. 576558 driver handle; Installs seal MCS 908250 / OEM 12013A and MCS 519891 / OEM 12035B on assembled transmission to correct dept...

Description Used to install 12026B & 12068 seals Fitment70-17 Big Twin (Excl. M8) (NU)Product Details Brand: Jims Category: TOOLS > TOOLS...

Description Used to support both sides of connecting rods when races are removed or installed; minimizing the possibility of distorting the female ...

Description Installs wristpin retaining ring MCS 508580 (OEM 22582-52 spiral lock type) in pistons with a .515" ID wristpin as used on many 1973 an...

Description Used to remove & install OEM style slotted oil pump and tappet screen plugs with a regular open end wrench to prevent damage to OEM...

Description Used to install outer retaining ring on the oil pump drive shaft Fitment36-99 Big Twin (Excl. Twin Cam) (NU)Product Details Brand: Ji...

Description Used to align oil pump to the cam support plate on Twin Cams. Helps reduce oil pump scavenging inefficiency due to oil pump misalignmen...

Description Used to line ream the pinion shaft bushing in the cam cover; Also reams idler gear bushing on Sportster models FitmentPinion bushing: 5...

Description Used to pull pinion shaft bushing from the cam cover. Note: A handy helping hand is the JIMS cam cover holding tool (MCS 978285) which ...

Description .108 inch diameter. Used to check pinion and cam gears for pitch diameters. A loose fit results in a clicking noise but a tight fit in ...

Description .105 inch diameter. Used to check pinion and cam gears for pitch diameters. A loose fit results in a clicking noise but a tight fit in ...

Description Used to lock pinion gear. Used with 513750 JIMS pinion gear socket for removal / installation of nut Fitment54-99 Big Twin (Excl. Twin ...

Description Used to install camshaft gear with correct timing; Note: Use 978387 tool to remove cam gear Fitment70-99 Big Twin (Excl. Twin Cam) (NU)...